《Variety》

     According to different rubber covering performance is divided into cold, acid, alkali resistant, oil resistant, wear resistant, etc.

According to different purposes of can be divided into elevator belt, belt, conveyor belt.

Depending on the structure can be divided into ordinary laminated type, and lateral impact resistant, laceration resistant enhancement layer.

《Specifications》

Material:

(1) with core NN100, NN150, NN200, NN250, NN300, NN350, NN400, NN450, NN500

(2) the bandwidth: 100 mm - 3000 mm

(3) layers: 1-10 layer

(4) cover gum: face: 1.5 8.0 mm not face: 1.5 to 4.5 mm

Characteristic: the thin belt body, high strength, impact resistance, good performance, interlayer adhesion strength, excellent flexing and long service life, etc, suitable for long distance, high capacity under the condition of high speed conveying material.

Model: NN80, NN125, NN100, NN150, NN200, NN300, NN400

Normal standard: GB/T7984-2001

General type flame retardant standard: GB/T10822-89

Specification: (1) bandwidth: 100 mm - 3000 mm (2 layers: 2-8 layer (3) rubber cover: face: 1.5 8 mm not face: 0 mm to 4.5 mm.

1, in transportation and storage, the belt should be kept clean and avoid direct sunlight or snow and rain leaching leaching, prevent from acid, alkali, oil, organic solvents, such as physical contact, and distance from the heating device one meter away.

2, storage warehouse temperature should keep a between 18 to 40 ℃, relative humidity should be kept between 50-80%.

3, during storage, the product must be placed in rolls, folding, should be placed during quarterly turn once.

4, layer number of different types and specifications of the conveyor belt should not be connect together to use, its connection with glue joint is best.

5, belt type, structure, specification and layer should be selected according to conditions of use reasonable.

6, conveyor belt running speed should not be commonly more than 2.5 m/s, big pieces, abrasion resistant materials and using fixed pear discharging device should be used as far as possible at low speed.

7, conveyor drive roller conveyor belt and the diameter of the relationship between layers, drive roller, redirection roller and the requirement for roller groove Angle should be prescribed according to the design of the conveyor, reasonable selection.

8, the feeding direction should be along the belt running direction, to reduce the material impact to tape down shall adopt chute, reduce material falling distance; Tape by material paragraph should shorten the roller, buffer roller spacing and used for the material leakage, take to use soft moderate keep-off board, in order to avoid gear plate quality, scraping the broken conveyor belt surface.

9, conveyer belt in use should be paid attention to the following: (1) avoid rollers is covered by the material, causing rotation is ineffective, prevent leakage of material between the roller and the tape, pay attention to the lubrication activities section, but not the oil conveying belt; (2) avoid loading starts; (3) belt running deviation, application to take steps to correct; (4) found that the local loss of viscose tape application repair, lest expanding;