4規格 specification
(1) 輪對重量：最大約2.0公噸
Wheel-set weight: about 2 ton
(2) 軌距：1,067 mm，附與廠區相同型式之鋼軌
Track gauge: 1067mm and used same track type with in workshop
(3) 車輪直徑：600~1,100mm
Wheel dia.: 600~1000mm
(4) 車輪寬度：約90-150mm
Wheel width: about 90~150mm
(5) 車軸長度：可配合車輛之車軸規格尺寸
Axle length of Wheel set: adapted to existing cars
(6) 車輪踏面輪廓：可配合車輛之車輪規格尺寸
Tread counter (wheel profile): adapted to existing casr
(7) 車削速度：30~120 m/min
Cutting (turning) speed: 30~120 m/min
(8) 容許鞍座移動速度範圍：3000mm/min及以上
Allowed saddle moving speed range: 3000mm/min or more
(9) 進刀量：約0.1~2.5 mm/rev
Cutting (turning) capacity : about0.1~2.5 mm/rev
(10) 精度要求：Accuracy requirement
A.同一車軸上兩車輪直徑許可差異：小於或等於0.2mm
Difference of dia. between 2 wheels on wheel set : 0.2mm or less
B.每一車輪之許可同心度及徑向偏差：小於或等於0.2mm
Allowed concentric and radial declination of wheel: 0.2mm or less
C.輪廓面失真之限度：小於或等於0.2mm。
Declination limitation of tread counter : 0.2mm or less
D.踏面表面精度：小於或等於12.5μm (Ra)
Surface accuracy of tread counter : 12.5μm (Ra) or less
E.鐵屑儲存桶(車)：2只x 2M3
Scrap storage barrel (car) : 2sets x2M3
(11) 電源：3相、380V、60Hz、AC
Power : 3phase, 380ACV ,60Hz
(12) 每輪對切削時間：約15~20min完成
Cutting (turning) time of each wheel set : about 15~20min completed
(13) 配(附)件齊全，本設備為達到功能需求，立約商應提供完整必須之配件，如電源、供水、排水、供氣、排氣、污水處理排放、電腦軟體等相關配件，以符合設備使用正常之要求
Complete accessories, for reached function requirements, contractor should completely provide necessary accessories, such as power, water supply, draining, air supply, air exhaust, sewage treatment discharge, computer software, etc. to comply with normal demands for equipment using.
